How much concrete does a fence post need?
A typical diamond mesh line pole in a 300 mm round hole, 600 mm deep, takes about 40 litres of concrete. That is less than one bag of cement mixed with sand and stone, or two to three 40 kg bags of ready-mix. Straining posts, corner posts and gate posts carry far more load, so they go deeper and wider: 400 mm across and 800 mm to 1 m deep is common, and heavy driveway gate posts often need more.
The calculator works out the volume of each hole, subtracts the space taken by the post, adds an allowance for waste and holes that end up larger than planned, and converts the total into cement, sand and stone or ready-mix bags.

Choosing the concrete mix
- General posts: line poles and palisade posts on firm ground are set in a general-purpose mix.
- Straining and gate posts: use a stronger mix with more cement, because these posts take the pull of the wire or the weight and swing of a gate.
- Gate motor plinths and heavy gates: use a strong mix and give it time to cure before mounting the motor or hanging the gate.
Use clean sand and stone, mix until the colour is even, and keep the concrete stiff rather than runny. Brace posts plumb while it sets. Leave at least a few days before tensioning wire against straining posts, and longer in cold weather.
Tips for setting fence posts
- Dig the hole slightly wider at the bottom than the top. The concrete then locks into the ground and resists being pulled out.
- Slope the top of the concrete away from the post so rainwater runs off instead of pooling against the steel.
- In clay or wet ground, put a little stone at the bottom of the hole for drainage.
- Set the corner and straining posts first, run a string line between them, then set the line poles to the string.
Get a quote for your project
The figures above are an estimate for planning. For an exact price, press Add these figures to my quote and send the form. A fencing contractor in your area will measure up and send you a free quote, with no obligation.
Frequently asked questions
How many bags of cement do I need per fence post?
For a standard line pole in a 300 mm hole 600 mm deep, about a quarter of a 50 kg cement bag mixed with sand and stone, or two to three 40 kg ready-mix bags. Gate and straining posts need much more. Enter your hole size into the calculator for an exact figure.
How deep should fence post holes be?
A common rule is that at least a third of the post's height above ground should go into the ground, so a 1.8 m fence needs holes of about 600 mm for line poles. Straining, corner and gate posts go deeper, often 800 mm to 1 m, and loose or sandy soil needs deeper holes.
Can I use ready-mix bags instead of mixing my own?
Yes. Ready-mix bags are easier for small jobs and a few posts, but cost more per cubic metre than buying cement, sand and stone separately. For a long fence with many posts, site-mixing is usually cheaper.





